Make Us Your Preferred Source
Add Phoenix Plumbing Co. as a preferred source on Google so our local plumbing advice shows up first in your results.

The short answer
New construction plumbing in Phoenix happens in three phases: the underground rough-in before the slab is poured, the top-out once the walls are framed, and the trim stage after drywall and tile. Each phase ends with a pressure test and a city inspection, and nothing moves forward until it passes. Whether you are building a custom home, a casita or a commercial space, that is the sequence our new construction plumbing team follows. Here is what happens in each phase and what to ask your builder.
Phase one: underground rough-in
Nearly every home in the Valley sits on a concrete slab, which means the drain lines, the sewer connection and the water supply stubs go in before there is a floor. We trench the pad, set the drain, waste and vent piping at the correct slope, run the water service in from the meter, and bring every line up through where a wall, toilet or island will eventually stand. Then we cap it, fill the drains with water, and the city inspector confirms it holds before the concrete crew is allowed to pour.
This phase matters more here than in colder states because once the slab is down, those pipes are buried for the life of the house. A sloppy underground is how a home ends up needing a slab leak repair twenty years later. Getting the layout right also means the kitchen island drain and the master bath are exactly where the plans say, because moving them after the pour means cutting concrete, which we explained in our post on what plumbing has to move in a kitchen remodel.
Phase two: top-out
After framing, we come back and run everything that lives inside the walls and ceiling: hot and cold supply lines to every fixture, drain and vent stacks up through the roof, the water heater location with its pan and vent, gas lines to the range and dryer if the home is gas, hose bibs, and a softener loop in the garage. Phoenix water runs 16 to 20 grains per gallon of hardness, so we rough in that loop on every new house whether or not the owner plans to install a softener on day one.
Top-out ends with a water test on the drains and a pressure test on the supply lines, held long enough to prove nothing weeps. The city inspects again. Only then do insulation and drywall go up, which makes this the last chance to add a side-yard hose bib, a pot filler, or a second water heater for a far bathroom at almost no extra effort.
Phase three: trim and final
Trim is the stage homeowners actually see. We set toilets, faucets, sinks, shower trim, the water heater, the disposal, the dishwasher connection and the hose bibs, then pressurize the whole house and check every joint. The final inspection covers fixtures, the water heater, backflow protection on any irrigation, and the gas test if applicable. Our plumbing installation service covers this phase for custom builds and for owners who bought fixtures themselves.
A custom build in north Phoenix that almost lost its island
We were brought onto a custom home near Cave Creek Road after the owner changed the kitchen layout two weeks before the slab pour. The original plans put the sink on the back wall; the new plans put it in a ten-foot island with a dishwasher beside it. Poured on the old layout, that island drain would have had no vent path and no way to reach the main without cutting the new slab. We re-ran the underground over two days, added an island vent the inspector approved, and the pour went ahead on schedule.
The honest counterpoint: the builder's plumber may be fine
If you are buying a production home from a large builder, you usually cannot choose the plumber, and most of the big subcontractors do solid work. Where it pays to bring in your own Phoenix plumbing contractor is a custom home, a casita or ADU, a detached shop with a bathroom, or a commercial build-out where you control the subs. Even on a production home, ask the builder three questions: is there a softener loop, is there a cleanout outside, and was the underground tested and inspected before the pour.
Planning a build? Talk to Phoenix Plumbing Co. about new construction plumbing
Phoenix Plumbing Co. has been family-owned since 2012, three generations deep, and we handle new construction plumbing for custom homes, casitas and commercial spaces across the Valley. Every job carries our written workmanship warranty, and a live Phoenix dispatcher answers the phone. Call 602-834-1208 or visit Phoenix Plumbing Co. to get your plans in front of a plumber before the pour.
Frequently Asked Questions
Have a plumbing question this article didn't answer? Call Phoenix Plumbing Co. — a live Phoenix dispatcher picks up, and we'll give you straight advice on the phone.